Also the software doesn’t remember our machine, so we have to assign that too every time. We have to basically reassign the origin every time. Lastly, when we restart the software, the coordinates are wrong, the origin is not where we set it last. As a result, when we try to burn on any mode besides the Line mode, the laser burns when moving from point to point burning also its path lines. The problem here is that when we change the mode to Fill or Line + Fill, the Cut Through menu disappears, and we haven’t found another way to make the laser stop when it’s moving from one burning point to another.
This allows the laser to stop when moving from one burning point to another, leaving no tracing lines behind. Next, when Line mode is on, we can control the Cut Through mode by setting a Start pause time and an End pause time.
The only way to shut it is to quickly pull off the usb that connects the machine to the pc, and then connect it again. When we first load the software, the laser of our machine turns on full blast. The software is really nice, but we have some strange things happening when we run it. We downloaded the trial version of Lightburn the other day to see if it will drive our GRBL 3018 well.
0 kommentar(er)
